Saturday, January 12, 2008

How to MAKE YOUR OWN COLLOIDAL SILVER

Introduction

You can make 8 ounces of COLLOIDAL SILVER at a time ( as you need it ) with a little bit of work and a little bit of money. YOU SHOULD BE ABLE TO GET THE SIMPLE IDEA OF WHAT I AM TRYING TO SHOW YOU FROM THE PICTURES. It really is a great simple idea. You don't need to do everything exactly as shown. The main idea is to get the wires hooked to the batteries and then be able to sit it on top of the glass with the wires dipped into the distilled water.

Instructions

Difficulty: Moderately Easy

Things You'll Need

  • Distilled water
  • A small 8 ounce glass
  • Two pieces of (99.999%)pure silver wire.(4 inches long.)
  • Three 9 volt batteries
  • One travel soap container.
  • Nine volt battery replacement snaps.
  • Alligator clips
  • A timer. ( to set your 35 min. time limit when making your colloidal silver.)
  • Wire cutters
  • Drill with small bit

Steps

1

Step One

Click to enlarge

THREE NINE VOLT BATTERIES

Put the three nine volt batteries together ( as shown in the picture )
2

Step Two

Click to enlarge

SET UP AND READY FOR THE SOAP DISH

The battery replacement snaps can then be attached to the batteries. YOU WILL NEED TO CAREFULLY SEPERATE THE POSITIVE AND NEGATIVE WIRES BY CUTTING IN BETWEEN THEM. Attach the positive on the positive and the negative on the negative posts of the batteries. NOW connect the alligator clips as shown. The alligator clips can then be clipped on to the silver wires. ( see the picture )
3

Step Three

Click to enlarge

SMALL HOLES DRILLED IN SOAP DISH

When you have the wires properly connected and you are able to sit the unit on top of the glass ( with the wires being about half an inch from the bottom of the glass ) . . .YOU ARE THEN READY TO TEST THE UNIT. Notice that I have drilled two small holes in the bottom of the soap dish to put the silver wires through.
4

Step Four

Click to enlarge

READY TO USE

TESTING THE UNIT . . . Put TAP WATER into the glass and then put the unit on top of the glass. ( WITH THE WIRE PRONGS IN THE WATER )After a few seconds you should see what looks like smoke coming from one of the wires. THIS MEANS THAT IT IS WORKING.
5

Step Five

Empty the tap water into your sink and replace it with distilled water. ( DO NOT USE TAP WATER TO MAKE YOUR COLLOIDAL SILVER.)
6

Step Six

When you have the glass almost filled with distilled water you then put the unit on top of the glass ( with the wire prongs in the water ) Set your timer and leave it in the glass for 35 minutes. ( NO LONGER ) There is no advantage to leaving it longer than 35 minutes.

No comments: